Daikin RDT-135c Installation And Maintenance Manual page 36

Mechanical Installation: RPS/RDT Factory Split at Condensing Unit
Install condenser support on air handler unit as shown in
7
Figure 43. Fill unused holes in unit base with bolts saved
intep 6.
If unit is post-and-rail mounted on a structural beam that
runs the full length of the unit, bolts and lifting brackets
were not removed. Omit this step.
Figure 43. Installing condenser support, Step 7
Figure 44. Setting condenser unit in place, Steps 8 and 9
34
Step 8: Lower condenser unit
until nearly level with main unit.
RFS unit
Lower the condenser unit until nearly level with main unit.
8
See Figure 44.
9 Carefully shift condenser unit until it rests against the main
unit. See Figure 44.
Do not damage piping components while setting
condensing unit in place.
Support condenser unit by crane during step 9 since
condenser support rail is not designed to withstand the
heavy lateral forces of a unit being slid over it.
RFS unit
Step 9: Carefully shift condenser unit
until it is resting against main unit.
CAUTION: Condenser support rail is
not designed to withstand heavy
lateral forces of unit being slid over it.
During this step, support condensing
unit with a crane.
CAUTION
CAUTION
Condenser
support rail
IM 738-2