3.10.3 Shortening The Adapter Tube Length; Fig 3-29 : Ferrule Installation; Fig 3-30 : Clean Cut Of Tube - Hach HIAC 9705 Operator's Manual

44 of 82

3.10.3 Shortening the Adapter Tube Length

The Large Volume Adapter is supplied with a 24-inch long tube. It has a two piece ferrule pre-
installed for connection into the sampling probe. The ferrule can not be re-used. If a shorter
sample tube is desired, then proceed through the following steps.
1) Leave the tube connected to the Large Volume Adapter. Cut the sampling probe end to
2) Carefully observe the loose stainless steel ferrule sleeve that has been supplied. Note
Operator Manual
the desired length. Make this cut clean and square. Leave the fitting nut on the tube as
shown. Save the tubing that was cut off and observe how the ferrule is installed on it.
that it has a flat end and the opposite end is sharp. It is a tapered sleeve.

Fig 3-29 : Ferrule Installation

Fig 3-30 : Clean Cut of Tube

System Setup - 9705
HIAC