Sharpening The Blade - Berkel 330M Instructions For Use, Installation And Maintenance

7 .2 SHARPENING THE BLADE

Pr oceed as follows as soon as it is noticed that
ther e is less cutting capacity:
W ARNING: Danger of cutting!
Use protective gloves which are resistant to
cutting and tearing and concentrate on the job
at hand.
PAY CAREFUL ATTENTION!
- Open the slice deflector (1 );
- Clean the blade with denatur ed alcohol or hot
water ;
- W ith the knob (2 ) r aise the cover of the
shar pener , tur n it 1 8 0 ° and lower it again;
- Star t the machine (only blade r otation);
M ove the lever (3 ) fr om the "0 " position to
-
the "sharpening" position and hold it in this
position for 1 0 - 1 5 seconds;
M ove the lever (3 ) to the "burr" position for
-
2 -3 seconds to r emove the shar pening bur r ;
Put the lever back to the "0 " position and
-
stop the blade movement;
- Raise the cover again, tur n it 1 8 0 ° and put it
back to its or iginal position;
- Clean the blade and the machine.
Note: do not insist more than 2 -3 seconds with
the burring operation so as to avoid damage to
the edge of the blade.
Installation, use and maintenance 3 3 0 M
1 8