Berkel 330M Instructions For Use, Installation And Maintenance page 11

Supply of machine and support column
The machine is supplied with also two washer s and two
bolts, put together with the feet.
If you have the machine with suppor t column A:
- Lift the machine car efully and inser t the following on
the base as shown in the figur e: position B the
r ubber holed foot; position A, C and D the nor mal
r ubber feet.
- Place the machine on the suppor t column by
inser ting the feet into the cups; for a cor r ect
positioning the suppor t column must be or iented so
that the black spot F on the base is on the same
side as the machine flywheel shaft.
- Adjust the position on the column r egulating the
height of the foot E.
- Check that the machine is cor r ectly settled on the
column, then lock the machine in place by inser ting
the scr ew in the B position going thr ough the cup
and r ubber foot, do not tighten it too much.
If you have the machine with suppor t column B:
- Lift the machine car efully and pay attention to
inser t the r ubber holed feet in or der to have the
same shape of the pedestal plate (mar ked with the
ar r ow) with the same shape of the machine.
- Place the machine on the suppor t column tr ying to
put the holed r ubber feet in cor r espondence of the
holes on the plate.
- Adjust the position on the column r egulating the
height of the foot E.
- Check that the machine is cor r ectly settled on the
column, then lock the machine in place by inser ting
the scr ews in the holes.
- Eliminate all the packaging (str aps, car dboar d,
polyur ethane foam
bags, etc.)
W ARNING: The packaging components (plastic str aps,
car dboar d, polyur ethane foam) can be thr own away
with nor mal solid wastes and ther efor e ther e is no
difficulty in disposing of them.
However it is advisable to dispose of
separ ately (differ ential collecting) in confor mity with the
r egulations in for ce for adequate r ecycling.
DO NOT DISCARD THE PACKAGING PRODUCTS IN THE
ENVIRONM ENT!
or polystyr ene, polyethylene
pr oducts
Installation, use and maintenance 3 3 0 M
A
B
1 0