Lubricating The Guide Bars Of The Carriage And Overplate; Adjusting The Chain - Berkel 330M Instructions For Use, Installation And Maintenance

7 .3 LUBRICATING THE GUIDE BARS OF THE CARRIAGE AND OVERPLATE

- After each cleaning oper ation of the machine
put a few dr ops of oil in the hole (1 ) of the
plate (2 );
- Put a few dr ops of oil along the sliding bar
(3 ) of the car r iage;
- Tur n the flywheel br iefly.
Note: Only use white Vaseline oil. Do not use
vegetable oils.

7 .4 ADJUSTING THE CHAIN

If you should hear a ticking noise when using the
machine check the tension of the blade chain as
follows:
- Loosen the two nuts (1 ) which hold the head
(2 );
- Raise the head (2 ) until the r equir ed tension
of the chain is obtained;
-
- Tighten the nuts and check.
Installation, use and maintenance 3 3 0 M
1 9