Table of Contents
Advertisement
7. MAINTENANCE AND REPAIRS
7.1 GENERAL INFORMATION
The operator is allowed to carry out the following
maintenance:
-
Blade sharpening, periodically; the interval and
length of the sharpening obviously depend on
the use of the machine (work times and type of
product used).
-
Lubrication of the carriage guide bars: weekly;
-
Adjustment of the bevel gear pair: as
necessary, see the relative paragraph.
7.2 SHARPENING THE BLADE
Proceed as follows as soon as it is noticed that there
is
less cutting capacity::
WARNING: Danger of cutting!
Use protective gloves which are resistant to cutting
and tearing and concentrate on the job at hand.
PAY CAREFUL ATTENTION!
-
Remove the slice deflector;
-
Clean the blade with denatured alcohol or hot
water;
-
Lift the cover (1);
-
Loosen the blocking knob of the sharpening
group (2);
-
Lift the sharpener (3) and turn it 180° (4);
-
Release it and completely retighten the blocking
knob;
-
Start the blade;
-
Carry out the sharpening of the blade by pressing
the sharpening grindstone button and keeping it
pressed for 10-15 seconds (5);
-
Press and mantain pressed for 2-3 seconds the
button of the finishing (6);
-
Stop the blade;
-
Replace the sharpener into the original position
and close the cover.
Note: do not insist more than 2-3 seconds with the
burring operation so as to avoid damage to the edge
of the blade.
Installation, use and maintenance B300
Maintenance to be carried out exclusively by
personnel authorised by the manufacturer is as
follows:
- Replacing the blade;
- Replacing the sharpener grindstones;
- Replacing the chain;
- Repairing the structural parts, repairing and/or
replacing components under the base.
12
Advertisement
Table of Contents
