Page 1
WNER PERATOR ANUAL 823E, ODELS 825E, 825A, 827E & 827A LICERS IMPORTANT NOTICE This manual contains Important Safety Instructions which must be strictly followed when using this equipment. 823E, 825E&A, 827E&A O WNER • 15 PERATOR ANUAL...
Page 2
EFORE SING QUIPMENT Berkel’s slicers are designed to slice meat and other food products safely and efficiently. However, unless the operator is properly trained and supervised, there is the possibility of a serious injury. It is the responsi- bility of the owner to ensure that this slicer is used properly and safely, strictly following the instructions contained in this manual and any re- quirements of local law.
UTILIZE UNICAMENTE los repuestos provistos por el fabricante. EN CASO de que los membretes de ‘PELIGRO’ se desprendan de la mçquina o sean illegibles, llame al fabricante o a su representante de service Berkel para que lo reemplace sin cargo. 2 • 823E, 825E&A, 827E&A O WNER...
Page 5
USE ONLY the attachments provided by the manufacturer. SHOULD any warning label on a machine come off or become unreadable contact the manufacturer or your designated Berkel service location for a free replacement. WARNING SHARP KNIFE BLADE 823E, 825E&A, 827E&A O...
3. Slide Product Table back and forth holding on to the Product Table Handle. If there is any rough operation or obstruction, shut off, unplug power cord and call your Berkel service- man. 4. Turn the slicer ON and check for smooth knife rotation. Turn the slicer OFF.
(See “Cleaning the Sharpening Stones,” page 7). If the stones are cracked or chipped they must be replaced. 5. Oil sharpener shafts. Place a few drops of Berkel Food Machine Oil on each shaft. Move the sharpening and deburring stone push buttons back and forth to make sure that the stones move in and out easily.
5. Shake excess water out and pat partially dry with paper toweling or a clean cloth towel. Set aside to air dry. 6. Once the stones are dry (after 24 hours), oil the shafts with Berkel Food Machine Oil. 7. Reassemble.
REMEMBER that the pusher is loose and can slide. 7. Tighten the product table locking knob. 8. Coat the pusher rod with a thin film of Berkel Food Machine Oil and move the pusher back and forth to distribute the oil.
3. Is the product positioned correctly and held securely on product table? If not, product may move or rotate during slicing operation resulting in partial or thick and thin slices. 10 • 823E, 825E&A, 827E&A O WNER ROUBLESHOOTING...
Page 13
4. Are you getting electricity from the wall outlet? Check by plugging in another piece of equipment with the same electrical requirements. Also, check circuit breaker or fuse 5. If you are getting electrical power and your slicer is still not operating, contact your Berkel serviceman.
EPAIR Please contact your Designated Berkel Service Location for any repair parts and/or repair service required on your Berkel slicer. Additional information may be obtained from: Service Support Center Berkel Company 4406 Technology Drive South Bend, Indiana 46628-9700 574/232-8222 · Fax 574/232-8116...
These warranties are given only to the first purchaser from a Berkel Authorized Chan- nel of Distribution. No warranty is given to subsequent transferees.
Need help?
Do you have a question about the 823E and is the answer not in the manual?
Questions and answers