7.2 SHARPENING THE BLADE
Proceed as follows as soon as it is noticed that there is
less cutting capacity:
WARNING: Danger of cutting!
Use protective gloves which are resistant to cutting
and tearing and concentrate on the job at hand.
PAY CAREFUL ATTENTION!
-
Open the slice deflector (1);
-
Clean the blade with denatured alcohol or hot water;
-
With the knob (2) raise the cover of the sharpener,
turn it 180° and lower it again;
-
Start the machine (only blade rotation);
-
Move the lever (3) from the "0" position to the
"sharpening" position and hold it in this position for
10- 15 seconds;
-
Move the lever (3) to the "burr" position for 2-3
seconds to remove the sharpening burr;
Put the lever back to the "0" position and stop the
-
blade movement;
-
Raise the cover again, turn it 180° and put it back to
its original position;
-
Clean the blade and the machine.
Note: do not insist more than 2-3 seconds with the
burring operation so as to avoid damage to the edge of
the blade.
15
Installation, use and maintenance 330M
15