Table of Contents
Advertisement
C
F
ALL
EATURES
GXW40XX supports the traditional te lephony features available in a PBX as well as additional advanced
telephony features.
T
6: C
F
ABLE
ALL
EATURES
Key
Call Features
Forcing a Codec (per call) *027110 (PCMU), *027111 (PCMA), *02723 (G72 3), *02729
*02
(G729), *0272616 (G726-r16), *0272624 (G724-r24), *0272632 (G726-r32), *0272640 (G726-
r40), *027201 (iLBC)
Disable LEC (pe call) Dial "*03" + " number ". No dial tone is played in the middle.
*03
*16
Enable SRTP
*17
Disable SRTP
Block CallerID (for all-config change)
*30
Send CallerID (for all-config change)
*31
Block CallerID (per call)
*67
Send CallerID (per call)
*82
Direct IP Calling. Dial "*47" + "IP address". No dial tone will be played in the middle. Detail see
*47
Direct IP Calling section on page 12.
Disable Call Waiting (for all-config change)
*50
Enable Call Waiting (for all-config change)
*51
Call Return Service: Dial *69 an d the pho ne will dial the last inco ming phone number
*69
received.
Disable Call Waiting (Per Call)
*70
Enable Call Waiting (Per Call)
*71
Unconditional Call Forward: Dial "*72" and then the forwarding number followed by "#". Wait
*72
for dial tone and hang up. (dial tone indicates successful forward)
Cancel Unconditional Call Forward: Dial "*73" and wait for dial tone, then hang up.
*73
Enable Paging Call: Dial "*74" and then the destination phone number you want to activate in
*74
Paging mode.
Enable Do Not Disturb (DND): When enabled all incoming calls will be rejected.
*78
Disable Do Not Disturb (DND): When disabled, incoming calls will be accepted.
*79
*87
Blind Transfer
Busy Call Forward: Dial "*90" and then the forwarding number followed by "#". Wait for dial
*90
tone then hang up.
Cancel Busy Call Forward: dial "*91". Wait for dial tone. Hang up.
*91
Delayed Call Forward: Dial "*92" and the n the forwarding number followed by "#". Wait for
*92
dial tone then hang up.
Cancel Delayed Call Forward: Dial "*93" for a dial tone, then hang up.
*93
If user hears call waiting beep, flash/hook will switch to the ne w incoming call. Also used to
Flash/Hook
switch to a new channel for a new call.
#
Pressing pound sign will serve as Re-Dial key.
Grandstream Networks, Inc.
T
(S
C
)
ABLE
TAR
ODE
GXW40XX User Manual
Firmware 1.0.5.10
Page 18 of 40
Last Updated: 01/2012
Advertisement
Table of Contents
