Control Cable - ZOLL thermogard xp Operation Manual

Figure 3-4.
5. Secure the control head to the mast by installing four screws in the holes
provided at the top of the mast. Use a Phillips screwdriver to tighten the
screws securely.

Control Cable

6. Connect the control cable to the socket on the lower right rear corner of
the control head. Align the plug with the socket and gently push the plug
into the socket until it is seated. Turn the retaining collar approximately
two full turns clockwise to lock the plug in the socket.
Figure 3-5.
Receiving, Inspection & Assembly
Attach the Control Head to the Mast.
Plug the Control Cable Into the Socket.
6
600479-001 Rev 2 30/147