The Coldwell - ZOLL thermogard xp Operation Manual

The Coldwell

4. Remove the cap from the coolant well and set it aside in a clean location.
5. Check the level of the coolant. The liquid level should be between the
two indicator lines on the wall of the coolant well. If the level is below the
bottom indicator line, add distilled water until the liquid is at the top
indicator line. If the coolant level is unusually low because of spillage,
add premixed propylene glycol and water until the liquid is at the top
indicator line.
Figure 4-37. Coolant Well Liquid Level Indicator Lines.
Figure 4-36. Coolant Well Cap.
34
Operation
600479-001 Rev 2 65/147