Thermo Scientific Smart2Pure Pro Installation And Operation Manual page 27

Figure 21. Remove the cover
2. a Locate the ultrapure cartridge.
b. Place the ultrapure cartridge in the rear section of the
system and insert the two quick connectors into the
ultrapure cartridge. When you hear an audible click
you can be sure that the quick connectors have been
inserted correctly.
Ultrapure
Cartridge
Figure 22. Quick Connectors
Note: The quick connectors are attached to the system in
such a manner so as to prevent installing the ultrapure
cartridge incorrectly.
3. a Locate the RO cartridge
b. Place the RO cartridge in the front part of the system
and insert the three quick connectors into the RO
cartridge. When you hear an audible click you can be
sure that the quick connectors have been inserted
correctly.
RO
cartridge
Bottom of
RO cartridge
Figure 23. Quick connectors
22 | Installation
Snapper
Cover
Figure 24. RO Flush kit
Quick
Connectors
4. Connect the power to the system (refer to the section
5. Turn the system ON by pressing ON/OFF key on the
6. Perform RO flush.
7. While RO is flushing, install sterile overflow and CO
8. After RO flush, remove RO Flush kit and reconnect
9. Mount the front cover back (removed in Step 1)
Top of
RO cartridge
Pure Water Tank Setup
Install Sterile Overflow
Quick
Connectors
Note: If you have ordered additional sterile tank overflow,
mount the tank overflow as described in its installation guide
provided with it.
If you have not ordered additional sterile tank flow, use a
AD 8 mm / 0.31 inch tube to connect the tank overflow fitting
connector with the drain. Route the AD 8 mm / 0.31 inch tube
with a free gravity fall to the drain. (refer to the section
Routing Tubes to Drain).
When changing the RO cartridge, connect the RO flush
kit (50157605) as shown in Figure 24 and run water to
drain for 30 minutes.
RO Flush Kit
Note: Repeat the process of flushing water when
replacing the RO cartridge.
Mounting the External Dispensing Valve to the
Smart2Pure Pro System (Optional)).
display.
filter on storage tank. See next section Pure Water Tank
Setup.
tubing.
Smart2Pure Pro Ultrapure water system
vent
2