Thermo Scientific Smart2Pure Pro Installation And Operation Manual page 10

• Wear safety gloves when working with
disinfection solutions.
• If your skin should come into contact with a
chlorine product, rinse it immediately with
ample, fresh water.
• The system, or system components, may
heat up as a result of a defect. It is
recommended to always wear appropriate
safety gloves to prevent skin damage or
burns.
• Wear safety gloves when changing the UV
lamp, in order to prevent that your skin comes
in contact with the UV lamp glass.
• Wear safety glasses when working with
disinfection solutions.
• If your eyes come into contact with a chlorine
product, rinse them immediately with ample,
fresh water and contact a physician at once.
• Check the UV-lamp before initial start.
• If the UV-lamp is broken
- Wear a breathing protector, filter category
FFP3 and replace the UV lamp. For
disposal the UV lamp refer to the section
Waste Disposal.
- Ventilate the room well.
Note: The Hg content in the UV lamp is so low so that no
damage to the environment can arise.
• To avoid tripping, ensure that the tubing do not lay over
the floor.
• Apply the general rules of hygiene for laboratories when
working with the system.
• Proceed as follows when the system has a defect:
- Switch the system OFF and unplug the system from
power outlet.
- Shut off the feed-water supply.
- Contact your local service organization.
Smart2Pure Pro Ultrapure water system Safety Precautions | 5