Genie S-65 XC Service And Repair Manual page 84

Service and Repair Manual
Hydraulic Pump
5 Carefully pull the drive pump out until the pump
coupler separates from the flex plate.
6 Remove the drive pump from the machine.
Component damage hazard. The
pump(s) may become
unbalanced and fall if not properly
supported.
Component damage hazard.
When installing the pump, do
not force the pump coupler into
the flexplate or damage to the
pump shaft seal may occur.
Component damage hazard. Be
sure to open the two hydraulic
tank valves and prime the pump
after installing the pump.
How to Prime the Pump
1 Connect a 0 to 600 psi / 0 to 41 bar pressure
gauge to the test port on the drive pump.
2 Remove the safety pin from the engine pivot
plate latch.
Note: The engine pivot plate latch is located under
the engine turntable pivot plate at the counterweight
end of the machine.
3 Open the engine pivot plate latch and swing
the engine pivot plate out and away from the
machine.
74
4 Ford models: Close the valve on the LPG
tank then disconnect the hose from the tank.
Then move the fuel select switch to the LPG
position.
Perkins 404D-22 models: Disconnect the
engine wiring harness from the fuel solenoid at
the injector pump.
Deutz D2011L03i, D436 L3i and TD2011L04i
models: Hold the manual fuel shutoff valve
clockwise to the closed position.
5 Have another person crank the engine with the
starter motor for 15 seconds, wait 15 seconds,
then crank the engine an additional
15 seconds or until the pressure reaches
320 psi / 22 bar.
6 Ford models: Connect the LPG hose to the
LPG tank and open the valve on the tank.
Perkins 404D-22 models: Connect the
engine wiring harness to the fuel solenoid.
Deutz D2011L03i, D436 L3i and TD2011L04i
models: Release the manual fuel shutoff
valve.
7 Start the engine from the ground controls and
check for hydraulic leaks.
® ™ ® ™
S -60 XC • S -65 XC
1 manual fuel shutoff valve
Part No. 1288652GT
September 2018