Genie S-65 XC Service And Repair Manual page 42

Service and Repair Manual
Repair Procedures
5 Disconnect the wire harness connected to the
DISCON and cut the zip ties securing the
harness to the ground box lid. Do not remove
the wire harness from the ground box.
Illustration 2
1 ground box lid
2 DISCON
3 ribbon cables
4 DISCON door
5 Torx head screws
32
6 Remove the DISCON door (4) and disconnect
the ribbon cables (3) from the Display
Controller (DISCON) (2). Note the orientation
of the cables for reassembling.
7 Remove the ground box lid (1) from the ground
box.
8 Remove the old overlay and clean the ground
box lid surface from any dirt, oils or old
adhesive residue. Clean the lid with 99%
isopropyl alcohol. Allow the surface to
completely dry.
9 Before placing the new overlay, make sure the
temperature of the lid and overlay is between
80-100° F / 26-38° C. Application below 80° F /
26° C is not recommended.
10 Peel the adhesive protective film from the back
of the overlay. Carefully align the overlay,
making sure the LCD screen cutout, push
buttons and key switch are centered. Apply the
overlay to the ground box, applying pressure
evenly to eliminate any air bubbles.
Note: Pay particular attention to the outside edges,
the LCD cutout edges and the area around the
ribbon cables, making sure there is complete
contact between the overlay and the ground box.
Note: It is not recommended peeling and reapplying
the overlay, so take time to align the overlay before
making contact with the ground box.
11 Maintain the temperature of 80-100° F / 26-38°
C for a minimum of 20 minutes to allow the
adhesive to cure.
12 Install the provided ribbon cables, first to the
overlay and then the DISCON. Be sure the
connectors are applied evenly in the sockets
and the tabs are fully locked.
® ™ ® ™
S -60 XC • S -65 XC
September 2018
Part No. 1288652GT