Genie S-65 XC Service And Repair Manual page 46

Service and Repair Manual
Platform Components
S-60 XC:
7 Support the rod end of the platform leveling
slave cylinder. Protect the cylinder rod from
damage.
8 Remove the pivot pin retaining fasteners from
both the slave cylinder rod-end pivot pin and
the rotator pivot pin.
9 Use a soft metal drift to remove both pivot pins.
Remove the platform rotator from the machine.
Crushing hazard. The platform
rotator may become unbalanced
and fall if not properly supported.
Note: When installing the platform rotator fasteners,
torque the fasteners to specifications.
10 Lower the jib boom leveling arms.
Crushing hazard. The platform
rotator may become unbalanced
and fall if not properly supported.
Note: When installing the platform rotator fasteners,
torque the fasteners to specifications.
36
S-65 XC:
11 Remove the pin retaining fasteners from the jib
boom and jib boom leveling arms to platform
rotator pivot pins. Do not remove the pins.
12 Support the jib boom leveling arms.
13 Use a soft metal drift to drive both pins out,
then remove the platform rotator from the
machine.
14 Lower the jib boom leveling arms.
Note: When installing the platform rotator fasteners,
torque the fasteners to specifications.
® ™ ® ™
S -60 XC • S -65 XC
September 2018
Bodily injury hazard. The jib
boom leveling arms may fall if
not properly supported.
Crushing hazard. The platform
rotator could fall when removed
from the machine if not properly
supported.
Part No. 1288652GT