Accessories; Introduction; Inlet Catchpot; Inlet Dust Filter - Edwards E2M28 Instruction Manual

7.5

Accessories

7.5.1

Introduction

A range of accessories is available for the E2M28 and E2M30 pumps, as shown in
The accessories are briefly described in the following sections. Refer to
accessories.
Accessory
ITO20K Inlet Catchpot
ITF20K Inlet Dust Filter
ITD20K Inlet Desiccant Trap
ITC20K Inlet Chemical Trap
EMF30 Outlet Mist Filter
PV25EK Valve: 200/240 V, 1-phase, 50/60 Hz
PV25EK Valve: 110/127 V, 1-phase, 50/60 Hz
FL20K Foreline Trap
Vibration Isolators (pack of four)
ODE 1/4 Oil Drain Extension
Pump Inlet Adaptor
Flexible Bellows
Pump Outlet Adaptor
Gas Ballast Banjo Elbow Assembly
Gas Ballast Valve: 110 V, 50/60 Hz
Gas Ballast Valve: 240 V, 50/60 Hz
7.5.2

Inlet catchpot

The Inlet Catchpot traps any liquid droplets and prevents their entry into the pump.
7.5.3

Inlet dust filter

The Inlet Dust Filter protects the pump against abrasive dust.
7.5.4

Inlet desiccant trap

Use a Desiccant Trap when pumping limited quantities of water vapour at high pumping speeds to a low vapour
pressure.
7.5.5

Inlet chemical trap

The Inlet Chemical Trap protects the pump against chemically active gases.
7.5.6

Outlet mist filter

The Outlet Mist Filter separates and traps oil droplets in the pump outlet to prevent oil mist discharge. The Mist Filter
is supplied with an adaptor to connect it to the pump outlet.
© Edwards Limited 2014. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Table 13 - Accessory item numbers
A373-10-880 Issue T
Figure 10.
Table 13 for the Item Numbers of these
Item Number
A441-10-000
A442-15-000
A445-10-000
A444-10-000
A462-33-000
C413-01-000
C413-03-000
A133-05-000
A248-01-412
A505-03-000
C105-20-201
C105-11-670
C105-01-414
A500-06-003
A500-06-984
A500-06-930
Page 37