Items Supplied With Your Test Stand; Accessories - Mecmesin OmniTest-5.0 Operation And Installation Manual

Hide thumbs Also See for OmniTest-5.0:

Table of Contents

1. Items Supplied with your Test Stand

When ordering your OmniTest-5.0 test stand you will be supplied with the following parts:

•

OmniTest-5.0 test stand,

Mains cable,

•

Document: A Guide to Safe Use of Mecmesin Mains Powered Test stands,

•

Document: OmniTest-5.0 Operation and Install Manual,

OmniTest-5.0 Foot Clamp,

•

Note: Accompanying VectorPro™ MT software may be supplied either via a physical flash

drive or software download link

For a full range of enhanced load sensors (ELS), extensometers and accessories, please go to

the Mecmesin website www.mecmesin.com, or your local distributor, as listed on the back

cover of this document.

• For connection of the stand to your computer system a Mecmesin supplied 2m USB B to

USB A cable communications cable is required (part no. 351-093).

 Here you can see some of the grips and fixtures that are available.

4  Mecmesin

OmniTest-5.0 Operating Manual

Table of Contents

Do you have a question about the OmniTest-5.0 and is the answer not in the manual?