13
Carriage start
.10.03
This function changes the time for starting the motors of the jig drive
(º = degree after t.d.c. needle bar).
Needle leaves the material,
carriage start at approx. 270°
The command for the carriage start is given when the needle pierces the material. The carri-
age, however, starts half a revolution later (180º), when the needle leaves the material.
(NIS)
Needle at t.d.c.
Needle in material,
continuous area of
180°
Under certain circumstances the stitch formation can be infl uenced by the
setting.
0°
Needle pierces the material,
command for carriage start
Adjustment
carriage stops,
is given at approx. 110°
149