Adjustment
13
Centering the needle in the needle hole
.05.07
● Insert adjustment pin 1 into the needle bar and screw tight.
● Loosen screws 2, 3 and 4.
● Pull out cylinder plunger 5 until it stops.
● Move needle bar frame 6 according to the requirement.
● Turn shaft 7 according to the requirement.
● Tighten screws 2, 3 and 4.
● Unscrew adjustment gauge 8 (part no. 61-778 162-15) and adjustment pin 1.
98
Requirement
When the cylinder plunger 5 is fully extended (straight stitch position), adjustment pin 1
must fi t precisely into the corresponding adjustment hole of the adjustment gauge 8.
2
7
Fig. 13 - 08
3
5
4
6
1
8