"Silence Alarm Devices; Silence Alarm Devices (Inside Switch) - Panasonic EBL512 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01457 Rev: -
8
8.1
Operating Instructions Fire alarm system EBL512, V2.7.x

"Silence Alarm devices"

In the control unit (on the FBP) there is a push button (P3) "Silence
Alarm devices".
If the push button "Silence Alarm devices" is pressed during a pre-
warning, a fire alarm or a Co-incidence alarm, the following will
happen:
 LEDs "Fire" (L1) and "Alarms queued"
blinking (0.4 / 0.4) to steady ON
 activated outputs
alarm devices), will be turned OFF
In case of a new alarm, or if the push button "Silence Alarm devices"
is pressed again, the sounders will automatically sound again and the
LEDs "Fire" and "Alarms queued" starts blinking.
NOTE! This is also valid for Pre-warning and Co-incidence alarm.

Silence alarm devices (inside switch)

NOTE! The functions in this chapter are valid for the New Zealand
convention only.
The button "Silence alarm devices" (P3) is called the "inside switch"
and has the following function:
The inside switch toggles between two states.
 Alarm devices disabled
All programmable outputs of type "Alarm devices" are
disabled, i.e. they cannot be activated.
 Alarm devices not disabled
All programmable outputs of type "Alarm devices" enabled,
i.e. they can be activated.
If the inside switch is in its disabled state when the c.i.e. door is being
closed the buzzer will beep once and the message "
" will be shown in the LCD. For priority order see
left active
chapter "Alphanumeric display (LCD) in EBL512", page 21.
NOTE! The inside switch has no function if the outside switch (see
below) is activated (ON).
29
When more than one fire alarm is activated.
30
Including Addressable siren 3377 and Addressable sounder base 3379.
28
29
30
, programmed for sounders (type 3 =
(L2) changes from
Silence switch