Optional Units - Mitsubishi FX-10GM User Manual

FX-10GM POSITIONING CONTROLLER

2.5 Optional Units

When an I/O connector of the positioning unit is connected to a terminal block, the
following cables are convenient.
Optional cables
The following optional cables are available to connect the positioning unit.
Positioning unit
FX-10GM
FX(E-20GM)
Applicable connectors
The specifications for connector cables made by the user and for the connectors
to be used when connecting additional equipment are indicated below.
1) When making a cable
Flat cables
Wire size:
Example of pressure displacement con-
nectors (female)
• HIF3BA-20D-2.54R
• FRC5-A020-3TOS
• FRC2-A020-30S
Separate wires
Wire size: AWG22 to 20 (0.3 to 0.5 mm
Solderless contacts: HU-411S (0.3 mm
Housing: HU-200S2-001
* Depending on the variation in sheath
thickness, it may be difficult to accom-
modate the wires in the housing.
UL-1061 wires are recommended.
16-points
FX-16E-150CAB type cable (1.5m)
FX-16E-300CAB type cable (3.0m)
FX-16E-500CAB type cable (5.0m)
CON1
FX-16E-150CAB-R type cable (1.5m)
CON1
FX-16E-300CAB-R type cable (3.0m)
CON2
FX-16E-500CAB-R type cable (5.0m)
FX-16E-500CAB-S type cable (5.0m)
AWG28 (0.1 mm
1.27 pitch, 20 cores
Hirose Denki
Daiichi Denshi
Daiichi Denshi
Daiichi Denshi
HU-411SA (0.5 mm
Daiichi Denshi
Daiichi Denshi
16-points
2) When connecting additional equipment
The destination side connectors to which
2
) M i t s u b i s h i ' s o p t i o n a l c a b l e s c a n b e
connected include the following models.
• HIF3BA-20PA-2.54DSA Hirose Denki
• FRC5-C20S53T-OL
• FRC2-C20S13-OL
The internal connectors of the positioning
unit and extension blocks are equivalent to
the models indicated above.
2
)
2
)
2
)
SPECIFICATIONS 2
Terminal block
Flat cable with
If no terminal
connector at both
block is used,
ends.
the cable can
Round multi-cored
be cut off at
cable with connector
one end.
at both ends.
Connector Separate wires
at one end.
Daiichi Denshi
Daiichi Denshi
2-6