Z-Suite Installation; Starting And Removing A Print - zortrax M200 Plus User Manual

Z-SUITE Installation

The latest Z-SUITE update can be found in the Downloads section at:
trax.com. To download and install Z-SUITE, you need to enter the serial number of your
printer. The serial number can be found in the printer's menu: Settings -> About Printer,
and on the nameplate at the back of the printer.
Remember to update Z-SUITE regularly. All updates are available at:
trax.com/downloads/.

Starting and Removing a Print

Once you have saved your model as a .zcodex file, you need to transfer it to the printer's
storage. There are two ways to do it: you can either save the file on the USB flash drive
and plug it into the port at the front of the printer, or you can transfer the file directly from
Z-SUITE over Wi-Fi/Ethernet cable.
To start the printing process, open the My Devices tab in Z-SUITE and select the printer
you want to work with. Next, open the 3D Printer Files and from all models saved on the
printer's storage, select the one you want to print and click the Print button.
You can also use the options from the main menu to print your model. Open the Select
Model tab and from all models, select the one you want to print and tap Print.
At this point the printer will start to heat up the extruder.
WARNING! The extruder will be hot. Don't touch it. Wear safety gloves.
The printing process will start automatically.
Remove the print very carefully because there are some elements of the printer that can
get damaged during the process. The following instructions show the correct procedure
of removing the print from the platform.
©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
https://support.zor-
http://support.zor-
39