Z-Suite Installation; Starting And Removing A Print - zortrax Inventure User Manual

Z-SUITE Installation

Download the latest Z-SUITE update from: http://support.zortrax.com/downloads/. In or-
der to download and install the Z-SUITE on your computer, you need to enter the serial
number of your device. The serial number can be found in the printer's menu in "Informa-
tion" section and on the nameplate on the back of the printer.
The Z-SUITE is a program created specifically for Zortrax devices. Thanks to this applica-
tion it is possible to prepare a 3D model for printing by generating a project and saving it
in a .zcode format. The program allows changing and adjusting the print settings, such as
the size of the model, the layer thickness, a type of infill or how much support structure
should be generated.
Remember to update the Z-SUITE regularly. All updates are available at:
zortrax.com/downloads/.

Starting and Removing a Print

Once your model has been prepared for 3D printing in the Z-SUITE, you need to save it
on your hard drive and then on an SD card. Next, insert the card into the card reader in
the printer.
Use the "Models" option from the main menu to choose the model you want to print. From
all the models saved on the SD card select the one to be printed press the middle button.
At this point the printer begins to heat up the extruder.
WARNING! The extruder will be hot. Don't touch it. Wear safety gloves.
The printing process will start automatically.
Removing the print needs to be dealt with very carefully because there are some elements
of the printer that can get damaged in the process. The following instructions show the
correct procedure of removing the print from the platform.
©2017, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
http://support.
33