Remote Control Of Motorcontroller; Commissioning And Test Run; The Motorcontroller Is Completely Installed, Without The Operating Voltage Applied - Window Master MotorController WCC 310 UL Installation Instructions Manual

Remote control of MotorController

18
It is possible to remote control a MotorController from a PC or via USB device.
When the MotorController is on a standard computer network (Ethernet) you can from any PC with the "WMaFlexiSmokeRemote"
program control the MotorController just like if you were standing in front of the itl.
If the MotorController is not connected to a network then it can be remote controlled via a USB connection using the
"WMaFlexiSmokeRemote" program.
The program "WMaFlexiSmokeRemote" can be downloaded from our webpages (www.windowmaster.com) under WCC 310 or
WCC 320.
Configuration of remote control
Identification of the IP-address
Screen shot from the PC when controlling
the FlexiSmoke™ remotely

Commissioning and test run

19
In case of hardware error, please see chapter 16 "Hardware error'"
We recommend that the software of the
The MotorController is completely installed, without the operating voltage
applied
a) Check all mechanical and electrical components for damage.
b) Check all screw and plug connections for tightness and/or firm seating
c) Check that all external components are installed:
1) ±24V actuators: Is the motor end module inserted in the last or only actuator?
Remote control can be configured in:
To enable remote control of the MotorController it is necessary to
allow remote control. This is done in the configuration of the system.
IP-address of the MotorController
Start the 'WMaFlexiSmokeRemote program' on the connected PC.
Enter the IP-address and press 'Connect'.
MotorController
is updated during the annual maintenance check!
38