Table of Contents
Advertisement
Configuring Basic H.323 Parameters
After accessing the Embedded Web Server (see
H.323 'Quick Setup' screen is displayed, shown in
Figure 7
V6100/H.323 Quick Setup
To configure basic H.323 parameters, follow these 8 steps:
1
If the V6100 is connected to a router with NAT enabled, perform the following procedure.
If it isn't, leave the 'NAT IP Address' field undefined.
Determine the "public" IP address assigned to the router (by using, for instance,
router Web management). Enter this public IP address in the 'NAT IP Address' field.
Enable the DMZ configuration on the residential router for the LAN port where the
V6100 gateway is connected. This enables unknown packets to be routed to the
DMZ port.
2
When working with a Gatekeeper, under 'H.323 Parameters', set 'Working with
Gatekeeper' field to 'Yes' and enter the IP address of the primary Gatekeeper in the field
'Gatekeeper IP Address'. When no Gatekeeper is used, the internal routing table is used
to route the calls.
3
Leave parameter 'Enable Annex D/T.38 FAX Relay' at its default unless your technical
requirements differ.
24
Accessing the Embedded Web
Figure 7.
V6100 Digital Gateway Installation Guide
Server) the
Advertisement
Table of Contents
