3Com v6100 Installation Manual page 42

6 In the 'Load an ini File' screen, you can now choose to either:
Click Browse and navigate to the ini file; the check box 'Use existing configuration',
by default checked, becomes unchecked. Click Send File; the ini file is loaded to the
V6100 and you're notified as to a successful loading.
Ignore the Browse button (its field remains undefined and the check box 'Use
existing configuration' remains checked by default).
Ignore the Browse button and uncheck the 'Use existing configuration' check box; no
ini file is loaded, the V6100 uses its factory-preconfigured values.
You can now choose to either:
Click Cancel; the V6100 resets utilizing the cmp, ini and all other configuration files
that were previously stored in flash memory. Note that these are NOT the files you
loaded in the previous Wizard steps.
Click Reset; the V6100 resets, utilizing the new cmp and ini file you loaded up to now
as well as utilizing the other configuration files.
Click Back; the 'Load a cmp file' screen is reverted to; see
Click Next; the 'Load a CPT File' screen opens, see
file or any other auxiliary file listed in the Wizard is optional.
Figure 18 Load a CPT File Screen
7
Follow the same procedure you followed when loading the ini file (see
procedure applies to the 'Load a VP file' (not applicable to the V6100 gateway) screen
and 'Load a coefficient file' screen.
42
Figure 15.
Figure 18; Loading a new CPT
Step
V6100 Digital Gateway Installation Guide
6). The same