Table of Contents
Advertisement
4
Select the coder (i.e., vocoder) that best suits your VoIP system requirements. The
default coder is: G.723.1 30 msec. To program the entire list of coders you want the
V6100 to use, refer to the V6100 Digital Gateway User Guide.
5
Map outgoing calls to IP addresses (when Gatekeeper isn't used) by completing these
steps:
Click the arrow button next to the 'Tel to IP Routing Table' label; the 'Tel to IP
Routing' screen opens.
Any telephone number whose destination number matches the prefix defined in the
'Destination Phone Prefix' field and whose source number matches the prefix defined
in the adjacent 'Source Phone Prefix' field, is sent to the IP address entered in the 'IP
Address' field.
Click the Submit button; the 'Tel to IP Routing' table is automatically updated.
Click Quick Setup; you're returned to the 'Quick Setup' screen.
6
For more information on the 'Tel to IP Routing' table refer to the H.323 V6100 Digital
Gateway User Guide.
7
Enable E1/T1 B-channels by completing these steps:
Click the arrow button next to the 'Trunk Group Table' label; the 'Trunk Group Table'
screen opens.
Select the number of the trunk you want to enable from the 'Trunk ID' drop-down list.
Enter the number of B-channels you want to enable in the 'Channels' field.
Enter the starting phone number in the adjacent 'Phone Number' field (these are
virtual numbers, used only to define enabled B-channels).
Click the Submit button; the 'Trunk Group Table' table is automatically updated.
Click Quick Setup; you're returned to the 'Quick Setup' screen.
8
Click the Reset button and click OK in the prompt; the V6100 applies the changes and
restarts.
9
After the gateway is reset, configure the V6100 trunk parameters. For information on
configuring the trunk parameters, see
H.323 users should continue with
V6100 Digital Gateway Installation Guide
Configuring the Trunk
Configuring the Trunk
Settings.
Settings.
25
Advertisement
Table of Contents
