Table of Contents
Advertisement
4
Enter the Proxy name in the field 'Proxy Name'. If Proxy name is used, it replaces the
Proxy IP address in all SIP messages. This means that messages are still sent to the
physical Proxy IP address but the SIP URI contains the Proxy name instead.
5
Configure 'Enable Registration' to 'Yes' or 'No':
'No' = the V6100 does not register to a Proxy server/Registrar (default).
'Yes' = the V6100 registers to a Proxy server/Registrar at power up and every
'Registration Time' seconds. For detailed information on the parameter 'Registration
Time' refer to the V6100 SIP User Guide.
6
Select the coder (i.e., vocoder) that best suits your VoIP system requirements. The
default coder is: G.723.1 30 msec. To program the entire list of coders you want the
V6100 to use, refer to the V6100 Digital Gateway User Guide.
7
Map outgoing calls to IP addresses (when Proxy isn't used) by completing these steps:
Click the arrow button next to the 'Tel to IP Routing Table' label; the 'Tel to IP
Routing' screen opens.
Any telephone number whose destination number matches the prefix defined in the
'Destination Phone Prefix' field and whose source number matches the prefix defined
in the adjacent 'Source Phone Prefix' field, is sent to the IP address entered in the 'IP
Address' field.
Click the Submit button; the 'Tel to IP Routing' table is automatically updated.
Click Quick Setup; you're returned to the 'Quick Setup' screen.
8
For more information on the 'Tel to IP Routing' table refer to the V6100 Digital Gateway
User Guide.
9
Enable E1/T1 B-channels by completing these steps:
Click the arrow button next to the 'Trunk Group Table' label; the 'Trunk Group Table'
screen opens.
Select the number of the trunk you want to enable from the 'Trunk ID' drop-down list.
Enter the number of B-channels you want to enable in the 'Channels' field.
Enter the starting phone number in the adjacent 'Phone Number' field (these are
virtual numbers, used only to define enabled B-channels).
Click the Submit button; the 'Trunk Group Table' table is automatically updated.
Click Quick Setup; you're returned to the 'Quick Setup' screen.
10 Click the Reset button and click OK in the prompt; the V6100 applies the changes and
restarts.
11 After the gateway is reset, configure the V6100 trunk parameters. For information on
configuring the trunk parameters, see
SIP users should continue with
V6100 Digital Gateway Installation Guide
Configuring the Trunk
Configuring the Trunk
Settings.
Settings.
27
Advertisement
Table of Contents
