Omron E5CC Communications Manual page 160

6 Programless Communications
(5) Check the value of parameters set in the upload area.
D000 to D014 is the upload area for the No. 0 Controller (E5CC), D030 to D044 is the
upload area for the No. 1 Controller, and D060 to D074 is the upload area for the No. 2
Controller.
With the default settings, the following parameters are set for the upload areas.
Check the values in the upload area to see if they are the same as those that are given in
the following table.
(It is not necessary to check addresses for which "---" is given in the Value column.)
No.0
D000 D030
D001 D031
D002 D032
D003 D033
D004 D034
D005 D035
D006 D036
D007 D037
D008 D038
D009 D039
D010 D040
D011 D041
... ...
D014 D044
* If the default settings are used and a sensor is not connected, the PV display on the E5CC will show an input
error and the process value in the upload area will be 1320 (528 hex).
6 - 46
No.1 No.2
D060 Response Flag (fixed)
D061 Communications Status (fixed)
D062 Communications Monitor
D063 Status (Upper Word)
D064 Status (Lower Word)
D065 Status 2 (Upper Word)
D066 Decimal Point Monitor
D067 PV
D068 Internal Set Point
D069 Heater Current 1 Value Monitor
D070 MV Monitor (Heating)
D071 Spare
... ...
D074 Spare
No.1 (D000 to D014)
No.2 (D030 to D044)
No.3 (D060 to D074)
Parameter
0
Alternates between 0 and 1.
---
---
---
---
---
PV*
---
---
---
---
...
---
E5@C Digital Temperature Controllers Communications Manual (H175)
Value