Table of Contents
Advertisement
On the 【Test Set】－>【Work mode】menu item the
key has to be pressed to
toggle between single point mode and scan mode.
5.8 Limit set
With the Limit set feature the user is able to set an audible and visual parameter while
taking measurements.
If a measurement is beyond the limit range, set by the user, the beeper will sound, if
enabled. With this, the speed and efficiency of the inspection process is improved by
elimination of constant viewing of the actual reading displayed. In the section below it
is described how to set up this feature:
1) On the 【Test Set】－>【Tolerance Limit 】menu item the
key has to be pressed
to activate the limit set screen.
2) The
key, the
and
key are to be used to change the bottom limit and the
upper limit value to the desired values.
3) The
key has to be pressed to confirm the change and to return to the previous
screen, or the
key has to be pressed to cancel the change.
If the measurement range is exceeded, the user will be reminded to re-set. If the bottom
limit is larger than the upper limit, the values will be exchanged automatically.
5.9 Changing resolution
The instrument has got a selectable display resolution, which is 0.1 and 0.01mm.
On the 【Test Set】－>【Resolution】menu item the
key has to be pressed to
switch between "high" and "low".
5.10 Unit scale
On the 【Test Set】－>【Unit 】menu item the
key has to be pressed to switch
back and forth between imperial and metric units.
16
TU_US-BA-e-1714
Advertisement
Table of Contents
