Table of Contents
Advertisement
If battery capacity runs out, the battery symbol
flash. In this case, the batteries should be replaced.
If the instrument isn't used for a longer period, the batteries have to be removed.
Anode
MT200
Cathode
M iTec
5.18 Connection to PC
This instrument is equipped with a USB port. Using the accessory cable, the instrument
has got the ability to connect to a PC or an external storage device.
Measurement data stored in the memory can be transferred to the PC through the USB
port. For detailed information of the communication software and its usage, refer to the
software manual.
6 Menu operation
Both, pre-setting system parameters and the additional function are verified by menu
operation. On the measurement screen, the
main menu.
6.1 Enter the main menu
To enter the main menu, the key
while being on the measurement screen. To turn back to the previous screen, the key
has to be pressed again.
6.2 Enter the Sub menu
The
key has to be pressed to enter the submenu screen while the submenu item is
selected.
6.3 Change the parameter
The
key has to be pressed to change the value of a parameter while the item is
selected on the parameter set screen.
6.4 Numeric digit input
TU_US-BA-e-1714
Procedure:
1 Power Off the instrument
2 Take off the cover of the battery and take out the
two batteries
3 Insert the new batteries into the instrument
two batteries
4 Re-plug the battery cover
5 Power on the instrument to check.
has to be pressed to activate the menu items tab
will be shown and it will begin to
key has to be pressed to get into the
19
Advertisement
Table of Contents
