Memory Scan - Yaesu FTM-100DR Operating Manual

Memory scan

Frequencies registered to the memory channels can be scanned in the memory channel
number order.
1
Switch to memory mode.
2
Press and hold [UP] or [DWN] on the microphone for
over one second.
Pressing [UP] scans the memory channels in an
upward direction.
Pressing [DWN] scans the memory channels in a
downward direction.
During scanning, the decimal point of the frequency
display blinks.
Once the transceiver receives a signal, the
transceiver continuously receives it until the signal
disappears, and restarts scanning 2 seconds after
the signal disappears.
Tips • The scanning direction (UP/DOWN) can be set from [5
SCAN] → [2 SCAN DIRECTION] in the Setup menu.
(This direction setting is also applied to scanning
performed using one of the [P1] to [P4] keys on the
microphone. The [SCAN] function can be assigned
to the key in advance using [8 CONFIG] → [10 MIC
PROGRAM KEY] in Setup menu).
• The scanning direction can be changed by pressing
and holding [UP] or [DWN] for over one second on the
microphone or rotating the DIAL during scanning.
• The receiver operation after scanning stops can be set
from [5 SCAN] → [3 SCAN RESUME] in the Setup
menu (refer to the previous page).
• Press
squelch level, even during scanning.
● Canceling scanning
To cancel scanning, press [PTT] on the microphone (this does not put the transceiver
into transmit mode).
, and then rotate the DIAL to adjust the
Searching for signals
53