Connecting The Transceiver; Connecting The Front Panel To The Main Body; Connecting The Microphone; Connecting The Antenna - Yaesu FTM-100DR Operating Manual

Connecting the transceiver

Connecting the front panel to the main body

Caution
Make sure to turn the transceiver OFF before connecting.
1
Connect the supplied control cable to the
transceiver main body.
Push the control cable plug into the CONTROL
jack on the front panel of the transceiver main
body, until it clicks.
2
Connect the other side of the front panel to the
control unit.
Push the other control cable plug into the
CONTROL jack on the transceiver control front
panel, until it clicks.

Connecting the microphone

1
Connect the supplied microphone to the main
body.
Plug the microphone connector into the MIC jack
on the front panel until it clicks.
Tips
• When disconnecting the microphone, pull the cable
while pressing the connector latch.
• Use the optional microphone extension kit "MEK-
2". An extension cable (Approx. 3 m) is supplied
with MEK-2 allowing you to operate further away
from the main body.

Connecting the antenna

1
Connect the coaxial cable to the main body.
Plug the coaxial cable jack into the ANT terminal
on the rear panel of the main body, then rotate
and tighten it.
22
Front panel
Control cable
Microphone
Connector
Main body
(rear panel)
Coaxial cable jack
Main
body
Control
cable
MIC
ABC DEF
1 2 3 A
GHI JKL MNO
4 5 6 B
PQRS TUV WXYZ
7 8 9 C
0 D
DTMF MICROPHONE
MH-48