Electrolux EDS Installation Manual page 24

24
ELECTROLUX ADDRESS
For a Compass Control/Compass Pro machine the EDS controller's address is pre-set to 000. For a Clarus Control
machine the EDS controller's address is pre-set to 001.
Make sure the washer extractor's address is also set to 0 or change the EDS controller's address to match the ad-
dress in the washer extractor.
Activate the ELECTROLUX ADDRESS menu and set the address.
ELECTROLUX ADDR.
000/001
Note!
The communication between the washer extractor and the EDS controller will not work if the addresses are
not the same.
The communication is verified by the presence of an asterisk (*) in the right corner on the bottom of the display.
ELECTROLUX
PROG
STEP
TIME
WGT
TEMP
EFF
MACHINE WEIGHT
Activate the MACHINE WEIGHT menu and set the capacity weight for the washer extractor. The capacity weight is
found on the label on the back of the machine.
MACHINE WEIGHT
DUAL CONTROLLER
This menu is only valid if you have two EDS Controllers and two pump stands connected to one machine.
Activate the DUAL CONTROLLER menu.
Select controller 1 or 2 or turn the function off.
DUAL CONTROLLER
OFF
CONTROLLER 1
CONTROLLER 2
Installation manual
S 12345
-
-
-
-
000
*