Installation Of The Eds Controller; General - Electrolux EDS Installation Manual

Installation manual
10
Connect the outlet tubes to the Flush manifold connections (B).
Connect one tube from the Flush manifold to the washer extractor (C).
Connect the water inlet (D).
fig.8057
Depress the locking tab (E) and remove the jumper harness (F) from the pump-stand (save the jumper harness for
future use if the Flush manifold might be disconnected). Connect the electrical cable from the Flush manifold to the
connection on the pump-stand when removed.
fig.W01149

2.6 Installation of the EDS controller

2.6.1 General

The EDS controller can be mounted on a wall or on the side panel on a washer extractor.
Connect the cables on the back of the EDS controller. Mount the mounting plate on its location and mount the EDS
controller on the mounting plate.
The mounting plate are mounted with the self-adhesive velcro hooks or with the nuts and Allen bolts (enclosed with
the kit). The self-adhesive velcro hooks shall be used if the EDS controller is to be mounted on a washer extractor.