Assignment Of The Do Component To The Device Component; Assignment Using Drag-And-Drop; Assignment Via Direct Input - Siemens SINUMERIK 840D sl Operating Manual

Configuring with EPLAN Add-In
5.4 Assigning drive objects
5.4.3

Assignment of the DO component to the device component

5.4.3.1

Assignment using drag-and-drop

You can assign a DO component to a device component using drag-and-drop.
DO components have to be assigned to EPLAN device components for CMC. This assignment
can be performed in EPLAN or subsequently in CMC.
Select the DO components from the DO list on the right-hand side in the "Assign drive objects"
window so that you can assign them on the left-hand side of the EPLAN device components.
The following is an "NCU710" example:
Figure 5-15 Assigning DO components to device components in EPLAN by drag-and-drop
1. Select the required drive object (DO) in the "Assign drive objects" window on the right-hand
side.
2. Click "DO name".
The component list belonging to the DO opens.
3. Select the required DO component and drag it to the required component line below the
device on the left-hand side
The "Assigned drive object" and the "Assigned component" are displayed immediately.
4. After completing the assignment, you can confirm the changes via the "Apply" or "Save and
close" button or reject them with the "Cancel" button.
When the assignment has been accepted, the DO name and the component name are
displayed in the preconfigured EPLAN property field for the appropriated devices.
DO and component are displayed separated by a ">", e.g. "NCU710>NCU_01". If there are
a number of subcomponents, they are separated by a semicolon.
5. If you want to delete an assignment, select the appropriate line of the device component
and delete it via the "Del" key.
6. If you what to delete all assignments of a drive object, select the drive object and press the
"Del" key.
5.4.3.2

Assignment via direct input

You can also enter the DO component of a device component directly via the provided property
field instead of using drag-and-drop (Page 30).
You will find further information on the standard use of the "EPLAN property" field in Section
"Minimum requirements in EPLAN regarding DRIVE-CLiQ topology" (Page 37).
30
SINUMERIK Integrate Create MyConfig - EPLAN Electric P8 Add-In
Operating Manual, 12/2017, A5E43099659B-AA