Expansion Modules Of The Control - Siemens SINUMERIK 840D sl Operating Manual

5.3.2

Expansion modules of the control

Configure the expansion modules (slaves) and external CUs as follows:
● Bus master / Bus coupler: Use the same value as already defined for the master.
● Position / Node ID: Enter the "Slave address" or the "Slave position".
● Master ID: The checkbox remains deactivated because the "Master ID" will not be set.
The "MasterSystemID" is not configured because it is determined automatically. The value
defined on the master is used based on the value of the "Bus master / Bus coupler".
Figure 5-11
SINUMERIK Integrate Create MyConfig - EPLAN Electric P8 Add-In
Operating Manual, 12/2017, A5E43099659B-AA
Example - external configuration - CU slave
Configuring with EPLAN Add-In
5.3 Define bus data
27