Minimum Requirements In Eplan Regarding Power Topology - Siemens SINUMERIK 840D sl Operating Manual

EPLAN adaptations

6.3 Minimum requirements in EPLAN regarding power topology

Pre-defined encoder connection names for SIEMENS devices:
● X100
● X520, X520/1, X520/2, X521, X531
● X261, X262, X2, Rail
Note
Evaluation error in DRIVE-CLiQ topology
If an error is recognized in the DRIVE-CLiQ topology, e.g. ring closure or duplicate wiring, the
sub-topology is not output as of the corresponding control unit (NX or NCU).
HLA modules
Note the following during configuration of HLA modules:
● The analog connection of the HLA valve, which is connected to the HLA module, must have
the name "X2".
● Represent the connection between the valve and the cylinder with standard power
connections. The name of the connection is "X1".
HF modules
Note the following during configuration of HF modules:
● Configure the cross rail between the sine filter and damping module using a power
connection. "Rail" is used as the connection name.
● As the cross rail between HF motor module and damping module is connected by DRIVE-
CLiQ, no further configuration is required.
6.3 Minimum requirements in EPLAN regarding power topology
The power topology describes the connections of the power supply of the modules and the
supply for the motors.
Predefined item designation for the port designation
The following predefined item designations for the port designation are recognized in EPLAN:
● DCN
● DCP
● IC
● L1
● X1, X2, X3, X4, X5
38
SINUMERIK Integrate Create MyConfig - EPLAN Electric P8 Add-In
Operating Manual, 12/2017, A5E43099659B-AA