Drive-Cliq Configuration; Define Bus Data - Siemens SINUMERIK 840D sl Operating Manual

Configuring with EPLAN Add-In

5.3 Define bus data

5.2.4

DRIVE-CLiQ configuration

In the "Settings..." dialog at "DRIVE-CLiQ type settings", specify the mapping for the attributes
in the "EPLAN property" field.
Figure 5-8 Settings - DRIVE-CLiQ type settings
Predefined EPLAN properties
The following attributes are already mapped per default in the "EPLAN property" field:
Table 5-1 Settings mapped on "EPLAN properties"
Configuration option
Order number
Device type
Drive object - assignment
5.3 Define bus data
Note
Take the EPLAN version into account
The EPLAN Add-In supports the evaluation and the export of the bus data as of EPLAN version
2.4.
Requirement
Take the following requirements into account:
● The bus data is configured in EPLAN for each connection.
● Set the display type of the connection to "Single-pole" so that you can enter the bus data
in the "Bus data" tab of the connection.
22
Description
This attribute reads the order number for the article. If a Sie‐
mens article was determined based on the order number, the
ports apply as described in the following sections.
This attribute determines the device type.
The device type is required to determine the DQ topology.
If the device type is missing and a connection is made to a
DQ device type, an error message is issued.
The drive object assignment and the component assignment
are saved in this attribute.
SINUMERIK Integrate Create MyConfig - EPLAN Electric P8 Add-In
Operating Manual, 12/2017, A5E43099659B-AA
Predefined "EPLAN proper‐
ties"
Order number
Function group
Additional field [1] – lan‐
guage-neutral