Right Handlebar Switches - Triumph Tiger 800 XCA 2007 Owner's Handbook Manual

General Information
The engine stop switch is for emergency
use. If an emergency arises which
requires the engine to be stopped, move
the engine stop switch to the STOP
position.
Note:
• Although the engine stop switch
stops the engine, it does not turn
off all the electrical circuits and
may cause difficulty in restarting
the engine due to a discharged
battery. Ordinarily, only the ignition
switch should be used to stop the
engine.
Caution
Do not leave the ignition switch in the
ON position unless the engine is
running as this may cause damage to
electrical components
discharge the battery.
Starter Button
The starter button operates the electric
starter. For the starter to operate, the
clutch lever must be pulled to the
handlebar.
Note:
• Even if the clutch lever is pulled to
the handlebar, the starter will not
operate if the side stand is down
and a gear is engaged.
Hazard Warning Lights Button
To turn the hazard warning lights on or
off, press and release the hazard
warning light button.
80
The ignition must be switched on for the
hazard warnings lights to be activated,
but the hazard lights will remain active
if the ignition is switched off until the
hazard warning light button is pressed
again.

Right Handlebar Switches

Tiger 800 XR Only
and will
1.
2.
3.
4.
5.
The following sections describe the
handlebar
functions.
Engine Stop Switch
In addition to the ignition switch being
turned to the ON position, the engine
stop switch must be in the RUN position
for the motorcycle to operate.
The engine stop switch is for emergency
use. If an emergency arises which
requires the engine to be stopped, move
the engine stop switch to the STOP
position.
1
5
Engine stop switch
STOP position
RUN position
Starter button
Hazard warning light switch
buttons
2
3
4
and switches