Triumph Tiger 800 XCA 2007 Owner's Handbook Manual page 59

TC Indicator Light Operation:
TC Switched On:
• Under normal riding conditions the
indicator light will remain off.
• The indicator light will flash rapidly
when the traction control system is
working to limit rear wheel slip dur-
ing periods of hard acceleration or
under wet or slippery road condi-
tions.
TC Switched Off:
The indicator light will not illuminate.
Instead the TC disabled warning light
will be illuminated (see page 59).
Note:
• Traction control will not function if
there is a malfunction with the ABS
system. The warning lights for the
ABS, traction control and the MIL
will be illuminated.
Traction Control (TC) Disabled
Warning Light
The TC disabled warning light
should not illuminate unless traction
control is switched off or there is a
malfunction.
If the warning light becomes illuminated
at any other time while riding, it
indicates that
system has a malfunction that requires
investigation.
the traction control
Engine Management System
Malfunction Indicator Light (MIL)
The Malfunction Indicator Light
(MIL) for the
system illuminates when the ignition is
switched ON (to indicate that it is
working) but should
illuminated when the engine is running.
If the MIL becomes illuminated when the
engine is running, this indicates that a
fault has occurred in one or more of the
systems controlled
management system.
circumstances, the engine management
system will switch to 'limp-home' mode
so that the journey may be completed, if
the fault is not so severe that the
engine will not run.
Warning
Reduce speed and do not continue to
ride for longer than is necessary with
the MIL illuminated. The fault may
adversely affect engine performance,
exhaust emissions
consumption.
Reduced engine performance could
cause a dangerous riding condition,
leading to loss of control and an
accident.
Contact an authorised Triumph dealer
as soon as possible to have the fault
checked and rectified.
Instruments
engine management
not become
by the engine
In
and
such
fuel
59