Triumph Tiger 800 XCA 2007 Owner's Handbook Manual page 182

Maintenance
LED Headlight Unit Adjustment for
Loaded Conditions
The headlight unit is equipped with an
adjuster lever to allow the vertical
adjustment to be corrected when the
motorcycle is fully loaded.
1
ckdt
1. Headlight adjuster
position)
2. Headlight adjuster
position)
For loaded conditions,
headlight adjuster lever until it is in
position (1). This will lower the headlight
beams by approximately 2°.
For normal (unloaded) conditions, the
headlight adjuster lever should be set in
the horizontal position (2).
182
2
lever (loaded
lever (unloaded
move the
Bulb Headlight Unit
Each headlight can be adjusted by the
vertical and horizontal
screws located on the rear of each
headlight. In addition, the headlight is
equipped with an easily accessible
adjuster to allow the vertical adjustment
to be corrected when the motorcycle is
fully loaded.
3
2
1. Horizontal (LEFT - RIGHT) adjustment
screw
2. Vertical (UP - DOWN) adjustment screw
3. Headlight adjuster lever for loaded
conditions
To adjust the headlight:
• Switch the headlight dipped beam
on.
• Turn the vertical (UP - DOWN) ad-
justment screw on the headlight
clockwise to raise the beam or anti-
clockwise to lower the beam.
• Turn the horizontal (LEFT - RIGHT)
adjustment
move the beam to the right or anti-
clockwise to move the beam to the
left.
• Switch the headlights off when the
beam settings are satisfactory.
adjustment
screw clockwise
1
to