Triumph Tiger 800 XCA 2007 Owner's Handbook Manual page 30

Instruments
Direction Indicators
When the indicator switch is
turned to the left or right, the indicator
warning light will flash on and off at the
same speed as the direction indicators.
Hazard Warning Lights
To turn the hazard warning lights on or
off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched off, until the
hazard warning light switch is pressed
again.
High Beam Button
When the high beam button is
pressed the high beam will be switched
on. Each press of the button will swap
between dip and high beam.
Note:
• If daytime running lights are fitted
to the motorcycle, the high beam
button has additional functionality.
If the DRL switch is in the daytime
running lights position, then press and
hold the high beam button to turn the
high beam on. It will remain on as long
as the button is held in and will turn off
as soon as the button is released.
30
Note:
• A lighting on/off switch is not fitted
to this model. The rear light and
licence plate
automatically when the ignition is
turned to the ON position.
• The headlight will function when
the ignition switch is turned to the
ON position. The headlight will go
off while pressing
button until the engine starts.
Daytime Running Lights (DRL)
Warning Light (if fitted)
When the ignition is switched
ON and the daytime running lights
switch is set to DAYTIME RUNNING
LIGHTS, the daytime running lights
warning light will illuminate.
The daytime running lights and low
beam headlights are operated manually
using a switch on the left hand switch
housing, see page 82.
light all function
the starter