Removing The Idsdm Card - Dell PowerEdgeFC430 Owner's Manual

Next steps
1 Followthe procedure listed inthe After working inside your systemsection.
Enter System Setup and ensure that the InternalSDCard Port is enabled.
2
3 Check if the newSD card is functioning properly. Ifthe problem persists, see theTroubleshooting an Internal SD Card section.
Related links
Safety instructions
Before working inside your system
Removing an internal SD card
After working inside your system
Troubleshooting an internal SD card

Removing the IDSDM card

Prerequisites
CAUTION: Manyrepairsmay onlybedonebyacertifiedservicetechnician. You shouldonlyperformtroubleshooting andsimple
repairsasauthorizedinyourproductdocumentation,
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1 Followthesafetyguidelineslistedinthe Safetyinstructions section.
2 FollowtheprocedurelistedintheBefore workinginside yoursystemsection.
3 If connected, disconnect all USBdevices.
4 Ifinstalled,removetheSDcard(s).
5 Remove the SSD cage.
6 Keep the Phillips #2 screwdriverready.
Steps
1 Remove the screws securing the IDSDM card tothe SSD cage.
2 Lift the IDSDM card till it disengages from the standoff and slide the IDSDM card away out of the SSD cage.
CAUTION: To prevent damage to the IDSDM card, you must hold the card only by its edges.
orasdirectedbytheonlineortelephoneserviceandsupportteam.
Installing and removing sled components 69