Removing A Processor - Dell PowerEdgeFC430 Owner's Manual

3 processor socket
2 Toremovea 140 W heat sink, perform the following steps.
a Loosen one of the screws that secure the heat sink over CPU 1 to the system board.
Wait 30 seconds for the heat sink to loosen from the processor.
b Remove the screwdiagonallyopposite the screwyoufirst removed.
c Repeat the procedure for the remaining four screws.
Figure 27. Removing the 140 W heat sink
1 screw hole(6)
3 processor socket (2)
Next steps
1 Remove the processor.
2 Followthe procedure listed inthe After working inside your systemsection.
Related links
Safety instructions
Before working inside your system
Removing the cooling shroud
Removing a processor
After working inside your system
Installing a heat sink

Removing a processor

Prerequisites
WARNING: The processor is hot to touch for some time after the system has been powered down. Allow the processor to cool
before removing it.
78 Installing and removing sled components
4 screw hole (4)
2 heat sink