Processors - Dell PowerEdgeFC430 Owner's Manual

Steps
1 Align the screw holes on the card with the standoffs on the system board.
CAUTION: To prevent damage to the LOM riser card, you must hold the card only by its edges.
2 Press the card into place until the card connector fits into the corresponding connector on the system board.
3 Secure the card with the two screws.
Figure 25. Installing the LOM riser card
1 LOMrisercard
3 standoff (2)
Next steps
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
After working inside your system
Removing the LOM riser card

Processors

The CPU contains memory, peripheral interfaces, and other components of the system.
Your system supports up to two Intel Haswell EP product family processors or Broadwell-EP 2S product family processors.
NOTE: The sled supports the following processors:
• Up totwo 120 W processors aresupported.
• A single 140 W processor is supported.
NOTE: Mixing processors of different wattages is not supported.
Use the following procedure when:
76 Installing and removing sled components
2 screw (2)
4 connector onthesystem board