Table of Contents
Advertisement
Deploying the T811-CM
In this section, you will mount the T811-CM in its final mounting location. Perform the following:
•
Mounting the T811-CM
•
Earth Grounding the T811-CM
•
Installing the Cable Power Tap
•
Powering the T811-CM with POC
•
Checking the T811-CM Signal Level with an RF Power Meter (Optional)
•
Configuring the T811-CM for the First Time (Optional)
Mounting the T811-CM
To mount the T811-CM assembly on a cable strand, you need to secure the cable clamps that are
attached to the strand interface to the cable strand.
1 Slightly loosen the nuts that fasten the two cable clamps to the strand interface, enough for the
strand support cable to fit into the cable clamps.
2 Place the cable clamps on the strand support cable.
3 Tighten the two cable clamp nuts to 22 to 27N.m (16 to 20 ft-lbs) to secure the mounting.
You have mounted the T811-CM. Continue with
T811-CM AP Installation Guide, 800-71436-001 Rev A
Earth Grounding the
T811-CM.
Installing the T811-CM
Deploying the T811-CM
23
Advertisement
Table of Contents
