Pqpz90 Enable/Disable Switching From Wgs84 To Pz-90.11 - Quectel L70 Command Manual

Parameter
<mode>
<initial distance>
<distance>
Example
$PQODO,W,1*23
$PQODO,W,OK*16
$PQODO,W,1,1000000*3E
$PQODO,W,OK*16
$PQODO,R*3B
$PQODO,R,1*26
$PQODO,Q*38
$PQODO,Q,123.45*0B
NOTES
1. The command will be effective immediately after setting.
2. After module is restarted, the PQODO write command must be executed again to re-start odometer
reading.
3. The command is not supported in backup mode.

2.9. PQPZ90 Enable/Disable Switching from WGS84 to PZ-90.11

PQPZ90 Enable/Disable Switching from WGS84 to PZ-90.11
Write Command
$PQPZ90,W,<mode>,<save>*ChkSum
<CR><LF>
Read Command
$PQPZ90,R*ChkSum<CR><LF>
URC Message
GNSS_SDK_Commands_Manual
Start or stop odometer reading
0 Stop odometer reading and remember the distance value
1 Start odometer reading and initialize the distance according to the <initial
distance>
Set the initial distance, range: 0-1e09, unit: meter
When <mode> is 1, this parameter can be omitted, and its default value is 0
When <mode> is 0, this parameter must be omitted
Current distance. Unit: meter
//Start odometer reading, and initial distance is 0m.
//Set OK
//Start odometer reading, and initial distance is 1,000,000m.
//Set OK
//Read mode
//Read OK, odometer reading has already been started
//Query the distance value
//Current distance value is returned
Response
$PQPZ90,W,OK*ChkSum<CR><LF>
If there is any error, response:
$PQPZ90,W,ERROR*ChkSum<CR><LF>
Response
$PQPZ90,R,<mode>*ChkSum<CR><LF>
$GNDTM,P90,x,xx.xxxx,x,xx.xxxx,x,xxx,W84*hh<CR><LF
>
GNSS SDK Commands Manual
Confidential / Released
GNSS Module Series
14 / 28