Fisher & Paykel ACTIVESMART RS9120W Installation Manual page 20

IMPORTANT!
The water connection instructions below are intended only for the professional installer.
● ●
Ensure water tubing is routed away from any sharp objects, sharp corners and not in a location where it can be kinked or squashed.
● ●
Beware of kinking the tube as this will stop water flow.
Connecting to the water tap
Move the refrigerator in front of
1
the cabinetry close enough to
allow access behind for power
and water connections (A).
B C
Uncoil the tubing from the
2
back of the product, and insert
the tubing firmly to water tap
connection (B).
– The tube should push in at
least 16mm before reaching
the stop.
Pull gently on tubing to ensure it
3
is locked in (C).
Secure connection by attaching
4
the locking key in between
the water tap connection and
locking collet (D).
18
!4 CONNECT TO WATER AND ELECTRICAL SUPPLY
A
D
Fasten the water tap connection to the cold
5
water supply tap. Take care not to over-tighten
the tap connection (E).
Note:
The water tap connection supplied should
● ●
fit most installation situations.
Turn isolating tap on and check that all
● ●
connections are dry and free of drips.
G
Firmly insert water tubing into the PRV. The tube should push in at least
6
5/8" (16mm) before reaching the stop. Once inserted, pull gently on tubing
to ensure it is locked in (F).
Secure the connection by attaching the locking key in between the
PRV and water tubing (G). Mount the PRV back into the clip.
4
3
E
F
2